 |
Chlorhexidine Gluconate Solution SDS Safety Data Sheet of Supplier Exporter Manufacturers' Representative |
Email: info@ammol.org |
Call Toll Free +1-855-552-6665 |
Chlorhexidine Gluconate Solution
CAS Number: 18472-51-0 Chlorhexidine Gluconate Solution
Molecular Formula: C34H54Cl2N10O14 Chlorhexidine Gluconate Solution
Molecular Weight: 897.76 Chlorhexidine Gluconate Solution
Chlorhexidine Gluconate Solution
Chlorhexidine Gluconate Solution or Chlorhexidine Digluconate Solution SDS, Safety Data Sheet
MSDS Sheet, Material Safety Data Sheet 04-Feb-24
1. Product Identification
Product Name & Other Names: Chlorhexidine Gluconate Solution or Chlorhexidine Digluconate Solution or 1,6-Bis(N5-[p-chlorophenyl]-N1-biguanido)hexane or 1,1′-Hexamethylenebis(5-[p-chlorophenyl]biguanide)
CAS No.: 18472-51-0
EINECS EC Number: 242-354-0
Relevant uses and uses advised against (if any): Laboratory and Industrial Use.
Supplier: American Molecules, 9910 Bent Oak Dr, Houston, TX 77040, USA.
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665.
In case of emergency contact: Will be given with the supply.
2. Hazards Identification
GHS, Globally Harmonized System Classification in accordance with 29 CFR 1910
Classification according to Regulation (EC) No 1272/2008
Skin Corrosion/irritation (Category 2) H315
Serious Eye Damage/Eye Irritation (Category 2) H319
Specific target organ toxicity (single exposure) - Respiratory system (Category 3) H335
Long-term (chronic) aquatic hazard (Category 3), H412
Labeling according to GHS USA & Regulation (EC) No 1272/2008
GHS Label Elements  Irritant |
Signal Words: Warning
Hazard Statements:
H315 Causes skin irritation.
H319 Causes serious eye irritation.
H335 May cause respiratory irritation.
H412 Harmful to aquatic life with long lasting effects.
Precautionary Statements:
P260: Do not breathe dust/fume/gas/mist/vapors/spray.
P264: Wash contaminated parts thoroughly after handling.
P270: Do not eat, drink or smoke when using this product.
P280: Wear protective gloves/protective clothing/eye protection/face protection.
P312: Call a POISON CENTER or doctor/physician if you feel unwell.
P301+P310: IF SWALLOWED: Immediately call a POSION CENTER or doctor/physician.
P302+352: IF ON SKIN: Wash with plenty of soap and water.
P303+361+353: IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing. Rinse skin with water/shower.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P333+313: If skin irritation or a rash occurs: Get medical advice/attention.
3. Composition/Information on Ingredients
Product Name & Other Names: Chlorhexidine Gluconate Solution or Chlorhexidine Digluconate Solution or 1,6-Bis(N5-[p-chlorophenyl]-N1-biguanido)hexane or 1,1′-Hexamethylenebis(5-[p-chlorophenyl]biguanide) 20% in water.
CAS No.: 18472-51-0
EINECS EC Number: 242-354-0
4. First Aid Measures
Always seek medical attention after first aid measures are provided.
Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Do not use mouth-to-mouth method if victim inhaled the substance. Induce artificial respiration with the aid of a pocket mask equipped with a one-way valve or other proper respiratory medical device. Get medical attention.
Ingestion: Rinse mouth. Do not induce vomiting without medical advice. If vomiting occurs naturally, have victim lean forward to reduce risk of aspiration. Never give anything by mouth to a victim who is unconscious or is having convulsions. Get medical attention.
Skin Contact: Wipe off excess material from skin then immediately flush skin with plenty of water for at least 15 minutes. Use a mild soap if available. Remove contaminated clothing and shoes. Get medical attention. Wash clothing before reuse. Thoroughly clean shoes before reuse. For minor skin contact, avoid spreading material on unaffected skin.
Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes, lifting lower and upper eyelids occasionally. Get medical attention immediately.
Notes to Physician: Treat symptomatically.
5. Fire Fighting Measures
Products of Combustion: Carbon oxides, nitrogen oxides, hydrogen chloride and toxic fumes.
Fire Extinguishing Media: Water fog. Alcohol foam. Polymer foam. Dry chemical powder. Carbon dioxide (CO2). Avoid a solid water stream as it may scatter and spread fire. Fire residues and contaminated fire extinguishing water must be disposed of in accordance with local regulations. In the event of fire and/or explosion do not breathe fumes.
Special Information: Fire may produce irritating, corrosive and/or toxic gases. In the event of a fire, wear full protective clothing and NIOSH-approved self-contained breathing apparatus with full face piece operated in the pressure demand or other positive pressure mode. Suppress (knock down) gases/vapors/mists with a water spray jet. Prevent fire extinguishing water from contaminating surface water or the ground water system.
6. Accidental Release Measures
Personal precautions: Ensure adequate ventilation. Keep people away from and upwind of spill/leak. Use personal protective equipment. Avoid dust formation. Avoid breathing vapors, mist or gas. Ensure adequate ventilation. Avoid breathing dust. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Ventilate closed spaces before entering. Keep out of low areas.
Environmental precautions: Prevent further spillage if safe to do so. Do not contaminate water.
Methods for cleaning-up: Clean up in accordance with all applicable regulations. Should not be released into the environment.
Small Spill: Avoid dust/mist formation. Avoid breathing dust/mist. Ensure adequate ventilation. Clean contaminated surface thoroughly.
Large Spill: Absorb with non-combustible inert substance. Sweep up and shovel. Keep in suitable, closed containers for disposal. Take care not to disperse material.
7. Handling and Storage
Precautions for safe handling: Avoid prolonged exposure. Apply according to good manufacturing and industrial hygiene practices. Ensure proper ventilation. Wash thoroughly after handling. Do not drink, eat or smoke while handling. Avoid contact with skin, eyes and clothing. Minimize dust generation. Avoid breathing dust/fumes/gas/mist/vapors/spray. Keep container tightly closed. Avoid ingestion and inhalation. Provide appropriate exhaust ventilation at places where dust is formed. Do not handle or store near an open flame, heat or other sources of ignition. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc.). All equipment used when handling the product must be grounded. Use only with adequate ventilation.
Conditions for safe storage, including any incompatibilities: Light and moisture sensitive. Store in cool, dry and ventilated area away from heat sources and protected from sunlight in tightly closed original container. Keep air contact to a minimum. Do not leave the material container open. Store protected from heat, sparks and ignition sources and incompatible materials. Avoid contact with skin and eyes. Avoid inhalation of dust/mist/vapor. Do not store with incompatible materials like oxidizing agents.
8. Exposure Controls/Personal Protection
Airborne Exposure Limits: Contains no substances with occupational exposure limit values.
Ventilation System: A system of local and/or general exhaust is recommended to keep employee exposures as low as possible.
Personal Respirators (NIOSH Approved): For conditions of use where exposure to dust or mist is apparent and engineering controls are not feasible, a particulate respirator may be worn.
Skin Protection: Wear protective gloves and clean body-covering clothing.
Eye Protection: Use chemical safety goggles and/or full face shield where dusting or splashing of solutions is possible. Maintain eye wash fountain and quick-drench facilities in work area.
Other Control Measures: Maintain good housekeeping in work area. Handle in accordance with good industrial hygiene and safety practice. Wash hands after handling.
9. Physical and Chemical Properties
Appearance: Colorless to faint yellow liquid.
Odor: Not available.
Odor threshold: Not available.
pH: 5.5 to 7.
Relative density: 1.06 to 1.07
Melting point/Freezing point: No data found.
Initial boiling point and boiling range: No data found.
Flash point: No data found.
Auto-ignition temperature: No data found.
Decomposition temperature: No data found.
Upper/lower flammability or explosive limits: No data found.
Vapor pressure: No data found.
Vapor density: No data found.
Evaporation rate: No data found.
Flammability (solid, gas): No data found.
Partition coefficient: n-octanol/water: No data found.
Solubility: Chlorhexidine Gluconate is miscible with water, with not more than 3 parts of acetone and with not more than 5 parts of ethanol (96 per cent).
Viscosity: No data found.
10. Stability and Reactivity
Stability: It is stable under ordinary conditions of use and storage.
Hazardous Decomposition Products: It emits carbon oxides, nitrogen oxides, hydrogen chloride, toxic fumes when heated to decomposition.
Hazardous Polymerization: Will not occur.
Incompatibilities: Oxidizing agents.
Conditions to Avoid: Avoid moisture, light, heat, sparks, open flames and other ignition sources. Contact with incompatible materials.
11. Toxicological Information
Toxicity data: No data found.
Carcinogenicity: Not expected to be hazardous by IARC, NTP, ACGIH, OSHA criteria.
Mutagenic Effects: No information available.
Reproductive Effects: No data found.
Developmental Effects: No data found.
Teratogenicity: No data found.
12. Ecological Information
Toxicity to fish: No information available.
Ecotoxicity: No data found.
Environmental effects: No data found.
Persistence and degradability: Soluble in water Persistence is unlikely based on information available.
Mobility in soil: Will likely be mobile in the environment due to its water solubility.
Results of PBT and vPvB assessment: No data found.
13. Disposal Considerations
Whatever cannot be saved for recovery or recycling should be managed in an appropriate and approved waste disposal facility.
14. Transport Information
Land Transport DOT USA TDG Canada & ADR/RID Europe: Not regulated.
Sea Transport IMO/IMDG: Not regulated.
Air Transport ICAO/IATA: Not regulated.
15. Regulatory Information
USA:
SARA 311/312 Hazards: See section 2.
California Prop. 65 Components: This product does not contain any chemicals known to State of California to cause cancer, birth defects, or any other reproductive harm.
Section 16 - Additional Information
European Labeling in Accordance with EC Directives:
H315 Causes skin irritation.
H319 Causes serious eye irritation.
H335 May cause respiratory irritation.
H412 Harmful to aquatic life with long lasting effects.
DISCLAIMER: The information and recommendations set forth herein are presented in good faith and believed correct as of the date hereof. It is compiled from various sources, and it is not necessarily all inclusive nor fully adequate in every circumstance. In addition, these suggestions should not be confused with nor followed in violation of applicable laws, regulations, rules, or insurance requirements applicable. This SDS MSDS sheet is intended only as a guide to the appropriate precautionary handling of the material by a professionally trained person using this product. Individuals receiving the information must exercise their independent judgment in determining its appropriateness for a particular purpose. This shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship. In no case shall our company be liable to loss or damages by the product user.
Please visit Main Page of Chlorhexidine Base and Chlorhexidine Gluconate Solution Suppliers.
American Molecules, also known as ammol.org is a distributor, supplier and manufacturers' representative of all types of Pharmaceuticals, Functional Ingredients, Excipients and Specialty Chemicals in Texas USA. Our principals manufacture supply and export USP NF BP, Ph Eur, etc grades of chemicals pure and reagent grade, mineral fortifiers, FCC food grade. Tailor made particle size and customized specifications are offered. The principal's facility is having one or more of the certifications like FDA approval and GLP, cGMP, ISO9001, ISO14001, ISO/IEC 17025, ISO22000, FSSC 22000, ISO45001, FSSAI, Kosher, HALAL, COPP, WHO-GMP certified and Written Confirmation (WC) for export to Europe is available. The manufacturers suppliers and exporters observe WHO Good Manufacturing Practices and Good Laboratory Practices.
Suppliers and Manufacturers' Representative:
9910 Bent Oak Dr
Houston, TX 77040, USA
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665
Email: info@ammol.org