 |
Chlorocresol or p-Chlorocresol or PCMC SDS Safety Data Sheet of Supplier Exporter Manufacturers' Representative |
Email: info@ammol.org |
Call Toll Free +1-855-552-6665 |
Chlorocresol or p-Chlorocresol or PCMC
CAS Number: 59-50-7
Molecular Formula: C7H7ClO or ClC6H3(CH3)OH
Molecular Weight: 142.58
Chlorocresol or p-Chlorocresol or PCMC
Chlorocresol or p-Chlorocresol or PCMC or 4-Chloro-3-methylphenol
SDS Safety Data Sheet
MSDS Sheet, Material Safety Data Sheet 04-Feb-24
Section 1. Product Information
Product Name & Other Names: Chlorocresol or p-Chlorocresol or PCMC or 4-Chloro-3-methylphenol.
CAS No.: 59-50-7
EINECS EC Number: 200-431-6
Supplier: American Molecules, 9910 Bent Oak Dr, Houston, TX 77040, USA.
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665.
In case of emergency contact: Will be given with the supply.
Section 2: Hazards Identification
GHS, Globally Harmonized System Classification in accordance with 29 CFR 1910
Classification according to Regulation (EC) No 1272/2008
Acute toxicity, oral Category 4, H302
Acute toxicity, Dermal Category 4, H312
Skin sensitization, Sub-category 1B, H317
Serious eye damage Category 1, H318
Short-term (acute) aquatic hazard Category 1, H400
Labeling according to GHS & Regulation (EC) No 1272/2008
GHS Label Elements  Aquatic Toxicity |
GHS Label Elements |
Signal Words: Danger
Hazard statements:
H302 + H312 Harmful if swallowed or in contact with skin.
H317 May cause an allergic skin reaction.
H318 Causes serious eye damage.
H400 Very toxic to aquatic life.
Precautionary statements:
P202: Do not handle until all safety precautions have been read and understood.
P260: Do not breathe dust/fume/gas/mist/vapors/spray.
P270: Do not eat, drink, or smoke when using this product.
P271: Use only outdoors or in a well-ventilated area.
P273: Avoid release to the environment.
P280: Wear protective gloves/protective clothing/eye protection/face protection.
P284: Wear respiratory protection.
P301+310: IF SWALLOWED: Immediately call a POISON CENTER or doctor/physician.
P304+340: IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing.
Section 3: Composition and Information on Ingredients
Product Name & Other Names: Chlorocresol or p-Chlorocresol or PCMC or 4-Chloro-3-methylphenol.
CAS No.: 59-50-7
EINECS EC Number: 200-431-6
Section 4. First Aid & Procedure
Always get medical attention after the first aid is over.
Ingestion: Never give anything by mouth to an unconscious person. Get medical attention.
Skin: Immediately flush skin with plenty of water for at least 15 minutes. Remove and wash contaminated clothing and shoes before reuse. Get medical attention if irritation develops.
Eyes: Immediately flush eyes with plenty of water for 15 minutes, occasionally lifting upper and lower eyelids. Hold eyelids apart during irrigation. Get medical attention.
Inhalation: Remove person to fresh air. If breathing is difficult, give oxygen. If not breathing administer artificial respiration. Get medical attention.
Section 5. Fire Fighting Measures
Flash Point: N/A
Extinguishing Medium: Water spray, alcohol-resistant foam, dry chemical or carbon dioxide.
Special hazards arising from the substance or mixture: Fumes may evolve along with carbon oxides and hydrogen chloride.
Fire Fighting Instructions: Use suitable protective equipment for surrounding fire.
Extinguishing Media Not recommended: Avoid using solid water jet as it may scatter the fire.
Special Information: In the event of a fire, wear full protective clothing and NIOSH-approved self-contained breathing apparatus with full face piece operated in the pressure demand or other positive pressure mode. At high temperatures under fire conditions, it may produce toxic or irritating fumes. Fire-extinguishing work is done from the windward and the suitable fire-extinguishing method according to the surrounding situation is used.
Section 6. Spills and Disposals
Personal precautions, protective equipment, and emergency procedures: Avoid breathing dust/fumes/gas/mist/vapors/spray. Ensure adequate ventilation. Do not touch or walk through this product. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc.). Restrict unprotected personnel from the area. Prevent any contact with hot surfaces. Do not approach facing the wind.
Environmental precautions: Do not let the product enter drains, soil, or water sources.
Methods and materials used for containment cleanup procedures and Storage: Contain spilled material. Cover with an inert, non-combustible absorbent material, (e.g., sand, earth, diatomaceous earth, vermiculite). Vacuum or sweep-up and remove to an approved disposal container.
Section 7. Handling and Storage
Harmful hazardous material. Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Avoid exposure.
Precautions for safe handling: Apply according to good manufacturing and industrial hygiene practices. Ensure proper ventilation. Wash thoroughly after handling. Do not drink, eat, or smoke while handling. Avoid contact with skin, eyes, and clothing. Minimize dust generation. Avoid breathing dust/fumes/gas/mist/vapors/spray. Avoid prolonged or repeated exposure. Keep container tightly closed. Avoid ingestion and inhalation. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc.).
Conditions for safe storage, including any incompatibilities: Store in cool, dry, and ventilated area away from heat sources and protected from sunlight in tightly closed original container. Keep air contact to a minimum. Do not leave the material container open. Store protected from heat, sparks and ignition sources and incompatible materials. Avoid contact with skin and eyes. Avoid inhalation of dust/mist/vapor. Do not store with incompatible materials like oxidizing agents.
Section 8. Exposure Controls & Personal Protection
Exposure Limits: Contains no components with established occupational exposure limits.
Engineering Controls: Use adequate exhaust ventilation to keep airborne concentrations below the allowable exposure limit.
Ventilation System: A system of local and/or general exhaust is recommended to keep employee exposures as low as possible.
Personal Respirators (NIOSH Approved): For conditions of use where exposure to dust or mist is apparent and engineering controls are not feasible, a particulate respirator may be worn.
Skin Protection: Wear protective gloves and clean body-covering clothing.
Eye Protection: Use chemical safety goggles and/or full-face shield where dusting or splashing of solutions is possible. Maintain eye wash fountain and quick-drench facilities in work area.
Other Control Measures: Maintain good housekeeping in work area. Handle in accordance with good industrial hygiene and safety practice. Wash hands after handling.
Section 9. Physical & Chemical Data
Appearance: White/pink solid.
Odor: Phenolic.
Odor threshold: Not available.
pH: No data found.
Relative density: 1.37 @ 20C.
Melting Point: 64C-67C literature.
Initial boiling point and boiling range: 235C literature.
Flash point: No data found.
Auto-ignition temperature: No data found.
Decomposition temperature: No data found.
Upper/lower flammability or explosive limits: No data found.
Vapor pressure: No data found.
Vapor density: No data found.
Evaporation rate: No data found.
Flammability (solid, gas): No data found.
Partition coefficient: n-octanol/water: No data found.
Solubility(ies): 3.8 g/l @20C in water.
Viscosity: No data found.
Section 10. Stability and Reactivity
Chemical Stability: Stable under normal temperatures and pressures.
Incompatibility (Materials to Avoid): Oxidizing agents, copper, and alloys.
Conditions to Avoid: Incompatible materials, excessive heat.
Hazardous Decomposition Products: Fumes may evolve along with carbon oxides and hydrogen chloride.
Hazardous Polymerization: Will not occur.
Section 11. Toxicological Information
Toxicity to Animals:
LC50 Inhalation - Rat - 4 h – >287 mg/l
LD50 Oral - Rat - 1830 mg/kg
LD50 Dermal - Rat - female - 2.000 mg/kg
Carcinogenicity: No component is present at levels greater than or equal to 0.1% is identified as probable, possible, or confirmed human carcinogen by IARC, NTP ACGIH or OSHA.
Mutagenic Effects: No data found.
Reproductive Effects: No data found.
Developmental Toxicity: No data found.
Section 12. Ecological Information
Toxicity to fish: semi-static test LC50 - Oncorhynchus mykiss (rainbow trout) - 0,92 mg/l - 96,0 h.
Toxicity to daphnia and other aquatic invertebrates: static test EC50 - Daphnia magna (Water flea) - 2,29 mg/l - 48 h.
Persistence and Degradability: Degradable.
Mobility: Likely to be mobile.
Bioaccumulation/ Accumulation: No data found.
Results of PBT and vPvB assessment: No data found.
Section 13. Disposal Suggestions
Dispose of in accordance with all applicable local, state, and federal regulations at an approved waste disposal facility.
Section 14. Transport and Label Information
Land Transport DOT USA, TDG Canada & ADR/RID Europe:
UN-No UN 3077
Proper Shipping Name: Environmentally hazardous substance, solid, n.o.s. (Chlorocresol)
Hazard Class 9, Packing Group III
Sea Transport IMDG/IMO:
UN-No UN 3077
Proper Shipping Name: Environmentally hazardous substance, solid, n.o.s. (Chlorocresol)
Hazard Class 9, Packing Group III.
Air Transport IATA/ICAO:
UN-No UN 3077
Proper Shipping Name: Environmentally hazardous substance, solid, n.o.s. (Chlorocresol)
Hazard Class 9, Packing Group III.
Section 15. Regulatory Information
USA:
SARA 311/312 Hazards: See section 2.
California Prop. 65 Components: This product does not contain any chemicals known to State of California to cause cancer, birth defects, or any other reproductive harm.
Section 16. Other Information
European Labeling in Accordance with EC Directives:
H302 + H312 Harmful if swallowed or in contact with skin.
H317 May cause an allergic skin reaction.
H318 Causes serious eye damage.
H400 Very toxic to aquatic life.
DISCLAIMER: The information and recommendations set forth herein are presented in good faith and believed correct as of the date hereof. It is compiled from various sources, and it is not necessarily all inclusive nor fully adequate in every circumstance. In addition, these suggestions should not be confused with nor followed in violation of applicable laws, regulations, rules, or insurance requirements applicable. This SDS MSDS sheet is intended only as a guide to the appropriate precautionary handling of the material by a professionally trained person using this product. Individuals receiving the information must exercise their independent judgment in determining its appropriateness for a particular purpose. This shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship. In no case shall our company be liable to loss or damages by the product user.
Please visit Main Page of Chlorocresol or p-Chlorocresol or PCMC Suppliers.
American Molecules, also known as ammol.org is a distributor, supplier and manufacturers' representative of all types of Pharmaceuticals, Functional Ingredients, Excipients and Specialty Chemicals in Texas USA. Our principals manufacture supply and export USP NF BP, Ph Eur, etc grades of chemicals pure and reagent grade, mineral fortifiers, FCC food grade. Tailor made particle size and customized specifications are offered. The principal's facility is having one or more of the certifications like FDA approval and GLP, cGMP, ISO9001, ISO14001, ISO/IEC 17025, ISO22000, FSSC 22000, ISO45001, FSSAI, Kosher, HALAL, COPP, WHO-GMP certified and Written Confirmation (WC) for export to Europe is available. The manufacturers suppliers and exporters observe WHO Good Manufacturing Practices and Good Laboratory Practices.
Suppliers and Manufacturers' Representative:
9910 Bent Oak Dr
Houston, TX 77040, USA
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665
Email: info@ammol.org