 |
Isopropyl Alcohol or Isopropanol SDS Safety Data Sheet of Supplier Exporter Manufacturers' Representative |
Email: info@ammol.org |
Call Toll Free +1-855-552-6665 |
Isopropyl Alcohol or Isopropanol
CAS Number: 67-63-0
Molecular Formula: C3H8O
Molecular Weight: 60.10
Isopropyl Alcohol or Isopropanol
Isopropyl Alcohol SDS, SAFETY DATA SHEET
MSDS SHEET, MATERIAL SAFETY DATA SHEET 04-Feb-24
1. PRODUCT AND COMPANY IDENTIFICATION
Product Name & Other Names: Isopropyl Alcohol or Isopropanol or 2-Propanol.
CAS Number: 67-63-0
EINECS EC Number: 200-661-7
FEMA: Number 2929
Relevant uses and uses advised against (if any): Industrial Manufacturing.
Supplier: American Molecules, 9910 Bent Oak Dr, Houston, TX 77040, USA.
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665.
In case of emergency contact: Will be given with the supply.
2. HAZARDS IDENTIFICATION
GHS, Globally Harmonized System Classification in accordance with 29 CFR 1910
Classification according to Regulation (EC) No 1272/2008
Flammable liquids Category 2, H225
Serious eye damage/eye irritation Category 2B, H319
Specific target organ toxicity - single exposure (Category 3), Central nervous system, H336
Labeling according to GHS & Regulation (EC) No 1272/2008
GHS Label Elements  Flammable Liquid |
GHS Label Elements |
Signal Words (GHS-USA): Danger
Hazard statements (GHS-USA):
H225 Highly flammable liquid and vapor.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.
Precautionary statements (GHS-USA):
P210: Keep away from heat/sparks/open flames/hot surfaces – No smoking.
P261: Avoid breathing vapors.
P271: Use only outdoors or in a well-ventilated area.
P280: Wear protective gloves/protective clothing/eye protection/face protection.
P302+352: IF ON SKIN: Wash with soap and water.
P305+351+338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do – continue rinsing.
P337+313: If eye irritation persists get medical advice/attention.
P403+235: Store in a well-ventilated place. Keep cool.
3. COMPOSITION / INFORMATION ON INGREDIENTS
Product Name & Other Names: Isopropyl Alcohol or Isopropanol or 2-Propanol.
CAS Number: 67-63-0
EINECS EC Number: 200-661-7
4. FIRST-AID MEASURES
Always seek medical advice after the first aid treatment.
Eye Contact: Rinse immediately with plenty of water for 10 minutes at least. Contact a physician if symptoms persist.
Skin Contact: Wash thoroughly with soap and water; flush with plenty of water. Take off spoilt clothes. Contact physician if symptoms persist.
Ingestion: Wash the mouth with water; seek medical advice immediately.
Inhalation: Remove from exposure site to fresh air and keep at rest. Obtain medical advice.
5. FIRE-FIGHTING MEASURES
Extinguishing Media Recommended: CO2, foam, dry chemicals, Water spray.
Non-Recommended: Do not use direct water jet on burning material.
Extinguishing Procedures: Closed containers may build up pressure at elevated temperatures. If possible, containers should be cooled with a water spray. For large fires, apply water from as far as possible. Keep containers and surroundings cool with water spray. Beware of vapors accumulating to form explosive concentrations. Vapors can accumulate in low areas.
Special Information: In the event of a fire, wear full protective clothing and NIOSH-approved self-contained breathing apparatus with full face piece operated in the pressure demand or other positive pressure mode. At high temperatures under fire conditions, it may produce toxic or irritating fumes.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment, and emergency procedures: Avoid breathing dust/fumes/gas/mist/vapors/spray. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc). Restrict unprotected personnel from the area. Prevent any contact with hot surfaces. Do not approach facing the wind.
Environmental precautions: Do not let the product enter drains, soil, or water sources.
Methods and materials used for containment Cleanup procedures and Storage: Contain spilled material. Cover with an inert, non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite). Vacuum or sweep up and remove to an approved disposal container. Avoid open flames or other sources of ignition.
7. HANDLING AND STORAGE
Precautions for safe handling: Apply according to good manufacturing and industrial hygiene practices. Ensure proper ventilation. Wash thoroughly after handling. Do not drink, eat, or smoke while handling. Avoid contact with skin, eyes, and clothing. Minimize dust generation. Avoid breathing dust/fumes/gas/mist/vapors/spray. Keep container tightly closed. Avoid ingestion and inhalation. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc).
Conditions for safe storage, including any incompatibilities: Store in cool, dry, and ventilated area away from heat sources and protected from sunlight in tightly closed original container. Keep air contact to a minimum. Do not leave the material container open. Store protected from heat, light, sparks and ignition sources and incompatible materials. Avoid contact with skin and eyes. Avoid inhalation of dust/mist/vapor. Do not store with incompatible materials like oxidizing agents, acid anhydrides, aluminum, halogenated compounds, ammonia, acids. Keep air contact to a minimum. Keep away from ignition sources and naked flame. - No smoking. Take measures to prevent the build-up of electrostatic charge.
8. EXPOSURE CONTROL
Exposure Limit Values:
ACGIH TWA (ppm): 200 ppm (2-propanol; USA; Time-weighted average exposure limit 8 h; TLV - Adopted Value)
ACGIH STEL (ppm):400 ppm (2-propanol; USA; Short time value; TLV - Adopted Value)
OSHA PEL (TWA) (ppm): 400 ppm.
Respiratory Protection: Avoid to breath directly on the product. Apply local ventilations when appropriate.
Ventilation System: A system of local and/or general exhaust is recommended to keep employee exposures as low as possible.
Personal Respirators (NIOSH Approved): For conditions of use where exposure to dust or mist is apparent and engineering controls are not feasible, a particulate respirator may be worn.
Skin Protection: Wear protective gloves and clean body-covering clothing.
Eye Protection: Use chemical safety goggles and/or full face shield where dusting or splashing of solutions is possible. Maintain eye wash fountain and quick-drench facilities in work area.
Other Control Measures: Maintain good housekeeping in work area. Handle in accordance with good industrial hygiene and safety practice. Wash hands after handling.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Clear colorless to yellowish liquid.
Odor: Characteristic.
Odor threshold: Not available.
pH: No data found.
Relative density: 0.785
Melting point/freezing point: -89.5C.
Initial boiling point and boiling range: 82C.
Flash point: 12C Closed cup.
Auto-ignition temperature: 425.0C.
Decomposition temperature: No data found.
Upper/lower flammability or explosive limits: No data found.
Vapor pressure: No data found.
Vapor density: No data found.
Evaporation rate: No data found.
Flammability (solid, gas): No data found.
Partition coefficient: n-octanol/water: No data found.
Solubility(ies): Soluble in water.
Viscosity: No data found.
10. STABILITY AND REACTIVITY
Reactivity: It presents no significant reactivity hazards, by itself or in contact with water. Avoid contact with strong acids, alkali, or oxidizing agents.
Decomposition: Carbon monoxide and unidentified organic compounds may be formed during combustion.
Conditions to Avoid: Heat, sparks, open flames, and other ignition sources. Avoid temperatures exceeding the flash point. Contact with incompatible materials. Oxidizing agents, Acid anhydrides, Aluminum, Halogenated compounds, Ammonia, Acids.
11. TOXICOLOGICAL INFORMATION
LD 50 ORAL/RAT (mg/Kg): 5000 mg/kg
LD 50 DERMAL/RABBIT (mg/Kg) >12800 mg/kg.
Carcinogenic Effects: Not a reported carcinogen by NTP, ACGIH, OSHA.
IARC: 3 - Group 3: Not classifiable as to its carcinogenicity to humans (2-Propanol).
Mutagenic Effects: No data found.
Developmental Toxicity: No data found.
Reproductive Effects: No data found.
12. ECOLOGICAL INFORMATION
Toxicity to fish LC50: Pimephales promelas (fathead minnow) - 9,640.00 mg/l - 96 h(2-Propanol)
Toxicity to daphnia and other aquatic invertebrates: EC50 - Daphnia magna (Water flea) - 5,102.00 mg/l - 24 h(2-Propanol)
Immobilization EC50 - Daphnia magna (Water flea) - 6,851 mg/l - 24 h(2-Propanol)
Results of PBT and vPvB assessment: This substance/mixture contains no components considered to be either persistent, bioaccumulative and toxic (PBT), or very persistent and very bioaccumulative (vPvB) at levels of 0.1% or higher.
Precautions: Prevent contamination of soil, ground and surface water.
13. DISPOSAL CONSIDERATIONS
In accordance with local environmental laws. Avoid disposing into drainage systems and into the environment.
14. TRANSPORT REGULATIONS
Land Transport DOT USA, TDG Canada & ADR/RID Europe:
UN Number: UN1219
Shipping Name: Isopropyl alcohol.
Hazard Class: 3; Packing Group: II.
Sea Transport IMDG/IMO:
UN Number: UN1219
Shipping Name: Isopropyl alcohol.
Hazard Class: 3; Packing Group: II.
Air Transport IATA/ICAO:
UN Number: UN1219
Shipping Name: Isopropyl alcohol.
Hazard Class: 3; Packing Group: II.
15. REGULATORY INFORMATION
USA:
SARA 311/312 Hazards: See section 2.
California Prop. 65 Components: This product does not contain any chemicals known to State of California to cause cancer, birth defects, or any other reproductive harm.
Section 16 - Additional Information
European Labeling in Accordance with EC Directives:
H225 Highly flammable liquid and vapor.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.
DISCLAIMER: The information and recommendations set forth herein are presented in good faith and believed correct as of the date hereof. It is compiled from various sources, and it is not necessarily all inclusive nor fully adequate in every circumstance. In addition, these suggestions should not be confused with nor followed in violation of applicable laws, regulations, rules, or insurance requirements applicable. This SDS MSDS sheet is intended only as a guide to the appropriate precautionary handling of the material by a professionally trained person using this product. Individuals receiving the information must exercise their independent judgment in determining its appropriateness for a particular purpose. This shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship. In no case shall our company be liable to loss or damages by the product user.
Please visit Main Page of Isopropyl Alcohol or Isopropanol Suppliers.
American Molecules, also known as ammol.org is a distributor, supplier and manufacturers' representative of all types of Pharmaceuticals, Functional Ingredients, Excipients and Specialty Chemicals in Texas USA. Our principals manufacture supply and export USP NF BP, Ph Eur, etc grades of chemicals pure and reagent grade, mineral fortifiers, FCC food grade. Tailor made particle size and customized specifications are offered. The principal's facility is having one or more of the certifications like FDA approval and GLP, cGMP, ISO9001, ISO14001, ISO/IEC 17025, ISO22000, FSSC 22000, ISO45001, FSSAI, Kosher, HALAL, COPP, WHO-GMP certified and Written Confirmation (WC) for export to Europe is available. The manufacturers suppliers and exporters observe WHO Good Manufacturing Practices and Good Laboratory Practices.
Suppliers and Manufacturers' Representative:
9910 Bent Oak Dr
Houston, TX 77040, USA
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665
Email: info@ammol.org