 |
Oxyclozanide SDS Safety Data Sheet of Supplier Exporter Manufacturers' Representative |
Email: info@ammol.org |
Call Toll Free +1-855-552-6665 |
Oxyclozanide
CAS Number: 2277-92-1
Molecular Formula: C13H6Cl5NO3
Molecular Weight: 401.46
Oxyclozanide
Oxyclozanide SDS, Safety Data Sheet
MSDS Sheet, Material Safety Data Sheet 06-Feb-25
1. Product Identification
Product Name & Other Names: Oxyclozanide.
CAS Number: 2277-92-1
EINECS EC Number: 218-904-0
Relevant uses and uses advised against (if any): Industrial Manufacturing.
Suppliers: As per letterhead.
2. Hazards Identification
GHS, Globally Harmonized System Classification in accordance with 29 CFR 1910
Classification according to Regulation (EC) No 1272/2008
Acute toxicity, Oral Category 4 - H302
Hazardous to the aquatic environment - Chronic Hazard, Category 1- H410
Labeling according to GHS USA & Regulation (EC) No 1272/2008
GHS Label Elements  Irritant |
GHS Label Elements |
Signal Words: Danger.
Hazard Statements:
H302: Harmful if swallowed.
H410: Very toxic to aquatic life with long lasting effects.
Precautionary Statements:
P260: Do not breathe dust/fume/gas/mist/vapors/spray.
P262: Do not get in eyes, on skin, or on clothing.
P270: Do not eat, drink or smoke when using this product.
P271: Use only outdoors or in a well-ventilated area.
P273: Avoid release to the environment.
P280: Wear protective gloves/protective clothing/eye protection/face protection.
P314: Get medical advice/attention if you feel unwell.
P305+351+338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do – continue rinsing.
3. Composition/Information on Ingredients
Product Name & Other Names: Oxyclozanide.
CAS Number: 2277-92-1
EINECS EC Number: 218-904-0
4. First Aid Measures
Always seek medical attention after first aid measures are provided.
Inhalation: Remove affected person to fresh air; if normal breathing has not returned within a few minutes after exposure, get medical attention.
Skin: Remove contaminated clothing; wash affected area with soap and water; launder contaminated clothing before reuse. Seek medical attention.
Eyes: Immediately, flush eyes for 15 minutes in clear running water while holding eyelids open; seek medical attention immediately.
Ingestion: Drink two glasses of water followed by milk, milk of magnesia or other non-alcoholic liquids; Do not induce vomiting; seek medical attention immediately.
5. Fire Fighting Measures
General Hazards: Contact with the eyes causes immediate severe irritation of the eye and eyelids. Product will support combustion.
Extinguishing Media: Carbon dioxide, dry chemical, chemical foam water fog. Do not use a heavy water stream as it can scatter the fire. Keep containers cool by spraying with water. Use extinguishing media appropriate for surrounding fire.
Fire & Explosion Hazard: May evolve oxides of carbon , oxides of nitrogen, chlorine compounds, and fumes under fire conditions.
In case of fire, wear a full face positive-pressure self contained breathing apparatus and protective suit. Self - contained respiratory equipment; cool containers to prevent pressure buildup and explosion when exposed to extreme heat.
Unusual Fire and Explosion Hazards: Closed containers can explode due to buildup of pressure when exposed to extreme heat.
Hazardous Combustion Products: Products of combustion include smoke, toxic fumes, oxides of carbon and nitrogen, chlorine compounds.
6. Accidental Release Measures
Personal precautions, protective equipment, and emergency procedures: Avoid breathing dust/fumes/gas/mist/vapors/spray. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc).
Environmental precautions: Do not let the product enter sewer, soil, or water sources.
Methods and materials used for containment cleanup procedures and Storage: Contain spilled material. Cover with an inert, non-combustible absorbent material, (e.g., sand, earth, diatomaceous earth, vermiculite). Vacuum or sweep up and remove to an approved disposal container. For large spills, confine spill, soak up with approved absorbent, shovel product into approved container for disposal.
7. Handling and Storage
Precautions for safe handling: Apply according to good manufacturing and industrial hygiene practices. Ensure proper ventilation. Wash thoroughly after handling. Do not drink, eat, or smoke while handling. Avoid contact with skin, eyes, and clothing. Minimize dust generation. Avoid breathing dust/fumes/gas/mist/vapors/spray. Keep container tightly closed. Avoid ingestion and inhalation. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc).
Conditions for safe storage, including any incompatibilities: Store in cool, dry, and ventilated area away from heat sources and protected from sunlight in tightly closed original container. Keep air contact to a minimum. Do not leave the material container open. Store protected from heat, sparks and ignition sources and incompatible materials. Avoid inhalation of dust/mist/vapor. Do not store with incompatible materials like strong oxidizing agents. Keep containers closed when not in use; protect containers from abuse; protect from extreme temperatures, open flames. This material will support combustion. Storage: Room temperature. Preferably refrigerate.
8. Exposure Controls/Personal Protection
Engineering Controls: The use of local exhaust ventilation is recommended to control emissions near the source. Provide mechanical ventilation of confined spaces. Use corrosion-resistant, explosion-proof ventilation equipment.
Exposure Limits: Not listed.
Personal Protection: Respiratory Protection (Specify Type): None required while threshold limits are kept below maximum allowable concentrations; if TWA exceeds standard workplace limits, NIOSH approved respirator must be worn.
Hand Protection: Neoprene, butyl or nitrile rubber gloves with cuffs.
Eye Protection: Chemical safety goggles.
Other Protective Clothing Or Equipment: Apron, or other equipment should be worn to prevent skin contact, safety eyewash station nearby. Practice safe workplace habits.
9. Physical and Chemical Properties
Appearance: White to off-white powder or crystals.
Odor: No information found.
Odor threshold: No information found.
pH: No information found.
Relative density: 1.6 estimated.
Melting point/freezing point: 208C literature.
Boiling Point: No information found.
Flash point: No information found.
Auto-ignition temperature: No information found.
Decomposition temperature: No information found.
Upper/lower flammability or explosive limits: No information found.
Vapor Pressure (MM Hg): No information found.
Vapor Density (Air = 1) : No information found.
Evaporation Rate (water = 1): No information found.
Flammability (solid, gas): No information found.
Partition coefficient: n-octanol/water: No information found.
Solubility: Very slightly soluble in water; freely soluble in acetone; soluble in ethanol (96%).
Viscosity: No information found.
10. Stability and Reactivity
Stability: Stable at normal temperatures and operating conditions.
Conditions to Avoid: Avoid excessively high temperatures and contact with strong oxidizing agents. Direct sunlight. Air contact.
Incompatibilities: Strong oxidizing agents.
Decomposition: Decomposition yields carbon oxides, chlorine compounds, nitrogen oxides and fumes.
Polymerization: Polymerization will not occur.
11. Toxicological Information
Acute toxicity:
Acute toxicity estimate Oral - 1000 mg/kg.
Carcinogenicity: No ingredient of this product present at levels greater than or equal to 0.1% is identified as probable, possible or confirmed human carcinogen by IARC, NIT, ACGIH or OSHA.
Mutagenic Effects: No information found.
Teratogenic Effects: No information found.
Developmental Toxicity: No information found.
Reproductive Effects: No information found.
12. Ecological Information
Toxicity to daphnia and other aquatic invertebrates: EC50 - Daphnia magna (Water flea) – 0.02 mg/l - 48 h.
Persistence and Degradability: No information found.
Mobility: No information found.
Bioaccumulation/ Accumulation: No information found.
Results of PBT and vPvB assessment: No information found for assessment.
13. Disposal Considerations
Dispose of it in accordance with Local, State, and Federal Regulations. Consult local, state, or Federal Environmental Protection Agency before disposing of any chemicals. Follow all the pollution control rules.
14. Transport Information
DOT USA, TDG Canada & ADR/RID Europe:
UN number: 3077
Proper Shipping Name: Environmentally hazardous substance, solid, n.o.s. (Oxyclozanide).
Hazard class(es) 9; Packing group: III.
IMDG/IMO:
UN number: 3077
Proper Shipping Name: Environmentally hazardous substance, solid, n.o.s. (Oxyclozanide).
Hazard class(es) 9; Packing group: III.
ICAO/IATA:
UN number: 3077
Proper Shipping Name: Environmentally hazardous substance, solid, n.o.s. (Oxyclozanide).
Hazard class(es) 9; Packing group: III.
15. Regulatory Information
No additional information is available.
Section 16 - Additional Information
Disclaimer:
**************************
Our company provides this MSDS sheet in good faith but makes no representation as to its comprehensiveness or accuracy. This SDS sheet is intended only as a guide to the appropriate precautionary handling of the material by a properly trained person using this product. The above information has been compiled from various sources and has the possibility of discrepancy and being out-dated information. Individuals receiving the information must exercise their independent judgment and do further search in determining its appropriateness for a particular purpose. In no case shall our company be liable to loss or damages by the product user.
**************************
Please visit Main Page of Oxyclozanide Suppliers.
American Molecules, also known as ammol.org is a distributor, supplier and manufacturers' representative of all types of Pharmaceuticals, Functional Ingredients, Excipients and Specialty Chemicals in Texas USA. Our principals manufacture supply and export USP NF BP, Ph Eur, etc grades of chemicals pure and reagent grade, mineral fortifiers, FCC food grade. Tailor made particle size and customized specifications are offered. The principal's facility is having one or more of the certifications like FDA approval and GLP, cGMP, ISO9001, ISO14001, ISO/IEC 17025, ISO22000, FSSC 22000, ISO45001, FSSAI, Kosher, HALAL, COPP, WHO-GMP certified and Written Confirmation (WC) for export to Europe is available. The manufacturers suppliers and exporters observe WHO Good Manufacturing Practices and Good Laboratory Practices.
Suppliers and Manufacturers' Representative:
9910 Bent Oak Dr
Houston, TX 77040, USA
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665
Email: info@ammol.org