Phenolphthalein SDS Safety Data Sheet of Supplier Exporter Manufacturers' Representative
Email: info@ammol.orgCall Toll Free +1-855-552-6665
Toll Free: 1-855-55-AMMOLPhenolphthalein
CAS Number: 77-09-8
Molecular Formula: C20H14O4
Molecular Weight: 318.32
PhenolphthaleinPhenolphthalein SDS, Safety Data Sheet
MSDS Sheet, Material Safety Data Sheet 17-Jan-25Section 1. Product Information
Product Name & Other Names: Phenolphthalein.
CAS No.: 77-09-8
EINECS EC Number: 201-004-7
Relevant uses and uses advised against (if any): Industrial Manufacturing.
Suppliers: As per letterhead.Section 2: Hazards Identification
GHS, Globally Harmonized System Classification in accordance with 29 CFR 1910
Classification according to Regulation (EC) No 1272/2008Germ cell mutagenicity Category 2, H341
Carcinogenicity Category 1A, 1B, H350
Reproductive toxicity Category 2, H361Labeling according to GHS & Regulation (EC) No 1272/2008
GHS Label Elements
Health HazardSignal Words: Danger
Hazard statements:
H341 Suspected of causing genetic defects.
H350 May cause cancer.
H361 Suspected of damaging fertility or the unborn child.Precautionary statements:
P201: Obtain special instructions before use.
P202: Do not handle until all safety precautions have been read and understood.
P281: Use personal protective equipment as required.
P304+340: IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing.
P308+313: IF exposed or concerned: Get medical advice/attention.Section 3: Composition and Information on Ingredients
Product Name & Other Names: Phenolphthalein.
CAS No.: 77-09-8
EINECS EC Number: 201-004-7Section 4. First Aid & Procedure
Always get medical attention after the first aid is over.
Ingestion: Never give anything by mouth to an unconscious person. Get medical attention.
Skin: Immediately flush skin with plenty of water for at least 15 minutes. Remove and wash contaminated clothing and shoes before reuse. Get medical attention if irritation develops.
Eyes: Immediately flush eyes with plenty of water for 15 minutes, occasionally lifting upper and lower eyelids. Hold eyelids apart during irrigation. Get medical attention.
Inhalation: Remove person to fresh air. If breathing is difficult, give oxygen. If not breathing administer artificial respiration. Get medical attention.Section 5. Fire Fighting Measures
Flash Point: N/A
Fire/Explosion: Not considered to be a fire and explosion hazard.
Extinguishing Medium: Water spray, alcohol-resistant foam, dry chemical or carbon dioxide.
Special hazards arising from the substance or mixture: Carbon oxides may evolve.
Fire Fighting Instructions: Use suitable protective equipment for surrounding fire.
Special Information: In the event of a fire, wear full protective clothing and NIOSH-approved self-contained breathing apparatus with full face piece operated in the pressure demand or other positive pressure mode.Section 6. Spills and Disposals
Personal precautions, protective equipment, and emergency procedures: Avoid breathing dust/fumes/gas/mist/vapors/spray. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc).
Environmental precautions: Do not let the product enter drains, soil, or water sources.
Methods and materials used for containment Cleanup procedures and Storage: Contain spilled material. Pick up and arrange disposal without creating dust. Sweep up and shovel. Keep in suitable, closed containers for disposal. Avoid dust formation. Avoid breathing vapors, dust/mist, or gas. Ensure adequate ventilation. Do not touch or walk through this product. Stop leak if safe to do so.Section 7. Handling and Storage
Precautions for safe handling: Use with adequate ventilation. Apply according to good manufacturing and industrial hygiene practices. Ensure proper ventilation. Wash hands before eating. Wash thoroughly after handling. Do not drink, eat, or smoke while handling. Avoid contact with skin, eyes, and clothing. Minimize dust generation. Avoid breathing dust/fumes/gas/mist/vapors/spray. Keep container tightly closed. Avoid ingestion and inhalation. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc). Avoid prolonged or repeated exposure.
Conditions for safe storage, including any incompatibilities: Store in cool, dry, and ventilated area away from heat sources and protected from sunlight in tightly closed original container. Keep air contact to a minimum. Do not leave the material container open. Store protected from heat, sparks and ignition sources and incompatible materials. Avoid inhalation of dust/mist/vapor. Do not store with incompatible materials like strong acids, bases, oxidizing agents (e.g. perchlorates, peroxides, permanganates) and strong reducing agents (e.g. phosphorus, tin (II) chloride, metal hydrides).Section 8. Exposure Controls & Personal Protection
Exposure Limits: Contains no substances with occupational exposure limit values.
Engineering Controls: Use adequate exhaust ventilation to keep airborne concentrations low.
Ventilation System: A system of local and/or general exhaust is recommended to keep employee exposures as low as possible.
Personal Respirators (NIOSH Approved): For conditions of use where exposure to dust or mist is apparent and engineering controls are not feasible, a particulate respirator may be worn.
Skin Protection: Wear protective gloves and clean body-covering clothing.
Eye Protection: Use chemical safety goggles and/or full face shield where dusting or splashing of solutions is possible. Maintain eye wash fountain and quick-drench facilities in work area.
Other Control Measures: Maintain good housekeeping in work area. Handle in accordance with good industrial hygiene and safety practice.Section 9. Physical & Chemical Data
Physical State: White Solid Powder or Crystals.
Odor: None
Odor threshold: Not applicable.
pH: No information found.
Relative density: 1.296
Melting Point: 261C - 263C
Initial boiling point and boiling range: > 450C
Auto-ignition temperature: 397 °C
Flash point: No information found.
Decomposition temperature: No information found.
Upper/lower flammability or explosive limits: No information found.
Vapor pressure: No information found.
Vapor density: No information found.
Evaporation rate: No information found.
Flammability (solid, gas): No information found.
Partition coefficient: n-octanol/water: No information found.
Solubility in water: Soluble
Viscosity: No information found.Section 10. Stability and Reactivity
Chemical Stability: Stable under recommended temperatures and pressures.
Incompatibility (Materials to Avoid): Strong acids, bases, oxidizing agents (e.g. perchlorates, peroxides, permanganates) and strong reducing agents (e.g. phosphorus, tin, chloride, hydrides).
Conditions to Avoid: Incompatible materials, excessive heat.
Hazardous Decomposition Products: Carbon oxides.
Hazardous Polymerization: Will not occur.Section 11. Toxicological Information
Toxicity to Animals: LD50 Oral - Rat - Not available.
Carcinogenicity: IARC: 2B - Group 2B: Possibly carcinogenic to humans.
Specific target organ toxicity: May cause damage to organs through prolonged or repeated exposure. Overexposure may cause reproductive disorder(s). May cause congenital malformation in the fetus. Suspected human reproductive toxicant.
Teratogenicity: No information found.Section 12. Ecological Information
Results of PBT and vPvB assessment: This substance/mixture contains no components considered to be either persistent, bioaccumulative and toxic (PBT), or very persistent and very bioaccumulative (vPvB) at levels of 0.1% or higher.
Mobility in Soil: No information found.
Environmental Precautions: DO NOT DISCHARGE into drains and rivers.
Acute Toxicity Daphnia: EC50 (Daphnia magna): > 4.34 mg/l/48hSection 13. Disposal Suggestions
Dispose of in accordance with all applicable local, state, and federal regulations at an approved waste disposal facility.
Section 14. Transport and Label Information
DOT USA, TDG Canada & ADR/RID Europe: Not regulated.
IMDG/IMO: Not regulated.
IATA: Not regulated.Section 15. Regulatory Information
USA:
SARA 311/312: See section 2.
California Prop.65: Contains a chemical known to the State of California to cause cancer: Phenolphthalein.
Suspected human reproductive toxicant.Section 16. Other Information
Disclaimer:
**************************
Our company provides this MSDS sheet in good faith but makes no representation as to its comprehensiveness or accuracy. This SDS sheet is intended only as a guide to the appropriate precautionary handling of the material by a properly trained person using this product. The above information has been compiled from various sources and has the possibility of discrepancy and being out-dated information. Individuals receiving the information must exercise their independent judgment and do further search in determining its appropriateness for a particular purpose. In no case shall our company be liable to loss or damages by the product user.Please visit Main Page of Phenolphthalein Suppliers.
American Molecules, also known as ammol.org is a distributor, supplier and manufacturers' representative of all types of Pharmaceuticals, Functional Ingredients, Excipients and Specialty Chemicals in Texas USA. Our principals manufacture supply and export USP NF BP, Ph Eur, etc grades of chemicals pure and reagent grade, mineral fortifiers, FCC food grade. Tailor made particle size and customized specifications are offered. The principal's facility is having one or more of the certifications like FDA approval and GLP, cGMP, ISO9001, ISO14001, ISO/IEC 17025, ISO22000, FSSC 22000, ISO45001, FSSAI, Kosher, HALAL, COPP, WHO-GMP certified and Written Confirmation (WC) for export to Europe is available. The manufacturers suppliers and exporters observe WHO Good Manufacturing Practices and Good Laboratory Practices.
![]()
![]()
![]()
![]()
Suppliers and Manufacturers' Representative:
9910 Bent Oak Dr
Houston, TX 77040, USA
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665
Email: info@ammol.org
18 April, 2025