 |
Hypo or Soda Bleach or Sodium Hypochlorite Solution Pentahydrate SDS Safety Data Sheet of Supplier Exporter Manufacturers' Representative |
Email: info@ammol.org |
Call Toll Free +1-855-552-6665 |
Toll Free: 1-855-55-AMMOL |
|
Hypo or Soda Bleach or Sodium Hypochlorite Solution Pentahydrate
CAS Number: 7681-52-9 Anhydrous, 7681-52-8 Pentahydrate
Molecular Formula: NaOCl Anhydrous
Molecular Weight: 74.44
Hypo or Soda Bleach or Sodium Hypochlorite Solution and Hypo or Soda Bleach or Sodium Hypochlorite Pentahydrate
Sodium Hypochlorite Solution SDS, Safety Data Sheet
MSDS Sheet, Material Safety Data Sheet 04-Feb-24
1. Product Identification
Product Name & Other Names Sodium Hypochlorite Solution or Soda Bleach or Hypo.
CAS No.: 7681-52-9 (anhydrous), 7681-52-8 (pentahydrate)
EINECS EC Number: 231-668-3
Relevant uses and uses advised against (if any): Industrial Manufacturing.
Supplier: American Molecules, 9910 Bent Oak Dr, Houston, TX 77040, USA.
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665.
In case of emergency contact: Will be given with the supply.
2. Hazards Identification
GHS, Globally Harmonized System Classification in accordance with 29 CFR 1910
Classification according to Regulation (EC) No 1272/2008
Skin corrosion (Category 1A B C), H314
Hazardous to the aquatic environment, acute hazard Category 1, H400
Labeling according to GHS & Regulation (EC) No 1272/2008
GHS Label Elements Corrosive |
GHS Label Elements |
Signal Word: Danger
Hazard Statements:
H314 - Causes severe skin burns and eye damage.
H400 - Very toxic to aquatic life.
Precautionary Statements - Prevention
P260: Do not breath dust/mist.
P264: Wash face, hands and any exposed skin thoroughly after handling
P271: Use only outdoors or in a well-ventilated area
P280: Wear protective gloves/ protective clothing/ eye protection/ face protection
P285: In case of inadequate ventilation wear respiratory protection
Precautionary Statements - Response
P302 + P352: IF ON SKIN: Wash with plenty of water.
P304+P340: IF INHALED: Remove person to fresh air and keep comfortable for breathing
P305 + P351 + P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P333 + P313: If skin irritation or rash occurs: Get medical advice/ attention.
P337 + P313: If eye irritation persists: Get medical advice/ attention
P342 + P311: If experiencing respiratory symptoms: Call a POISON CENTER or doctor.
3. Composition/Information on Ingredients
Product Name & Other Names Sodium Hypochlorite Solution or Soda Bleach or Hypo.
CAS No.: 7681-52-9 (anhydrous), 7681-52-8 (pentahydrate)
EINECS EC Number: 231-668-3
Percentage: 5% to 25% active in water.
4. First Aid Measures
Always seek medical attention after first aid measures are provided.
Inhalation: If inhaled, remove to fresh air. If breathing is difficult, give oxygen. Get medical attention.
Ingestion: Do not induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person. If large quantities of this material are swallowed, call a physician immediately. Loosen tight clothing.
Skin Contact: Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Get medical attention. Wash clothing before reuse. Thoroughly clean shoes before reuse.
Eye Contact: Check for and remove any contact lenses. In case of contact, immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention.
5. Fire Fighting Measures
Fire: It is not combustible, but substance is an oxidizer diluted with water.
Fire Extinguishing Media: Dry chemical, carbon dioxide. Do not use a heavy water stream.
Special hazards arising from the substance or mixture: Hydrogen chloride gas, Chlorine and Sodium oxide with along with irritating fumes.
Special Information: This oxidizing material can increase the flammability of adjacent combustible materials. In the event of a fire, wear full protective clothing and NIOSH-approved self-contained breathing apparatus with full face piece operated in the pressure demand or other positive pressure mode. At high temperatures under fire conditions, it may produce toxic or irritating fumes. Fire-extinguishing work is done from the windward and the suitable fire-extinguishing method according to the surrounding situation is used.
6. Accidental Release Measures
Personal precautions, protective equipment, and emergency procedures: Avoid breathing dust/fumes/gas/mist/vapors/spray. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc.). Restrict unprotected personnel from the area. Prevent any contact with hot surfaces. Do not approach facing the wind.
Environmental precautions: Do not let the product enter drains, soil, or water sources.
Methods and materials used for containment Cleanup procedures and Storage: Oxidizing material diluted with water, as required. Neutralize spill. Do not inhale dust, vapors, mist, or gas. Avoid dust formation. Contain spilled material. Cover with an inert, non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite). Use a shovel to put the material into a convenient waste disposal container. Finish cleaning by spreading water on the contaminated surface and allow to evacuate as per law.
7. Handling and Storage
Precautions for safe handling: Apply according to good manufacturing and industrial hygiene practices. Ensure proper ventilation. In case of insufficient ventilation, wear suitable respiratory equipment. Wash thoroughly after handling. Do not drink, eat, or smoke while handling. Avoid contact with skin, eyes, and clothing. Minimize dust generation. Avoid breathing dust/fumes/gas/mist/vapors/spray. Keep container tightly closed. Avoid ingestion and inhalation. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc.).
Conditions for safe storage, including any incompatibilities: Store in cool, dry, and ventilated area away from heat sources and protected from sunlight in tightly closed original container. Keep air contact to a minimum. Store protected from heat, sparks and ignition sources and incompatible materials. Avoid contact with skin and eyes. Avoid inhalation of dust/mist/vapor. Do not store with incompatible materials like strong oxidizing agents, strong reducing agents, powdered metals, amines, ammonia, strong acids, organic materials, methanol. Isolate from any source of heat or ignition. Avoid storage on wood floors. Separate from organic or other readily oxidizable materials.
8. Exposure Controls/Personal Protection
Airborne Exposure Limits: 2 mg/m3 STEL.
Ventilation System: A system of local and/or general exhaust is recommended to keep employee exposures as low as possible.
Personal Respirators (NIOSH Approved): For conditions of use where exposure to dust or mist is apparent and engineering controls are not feasible, a particulate respirator (NIOSH type N95 or better filters) may be worn.
Skin Protection: Wear impervious protective clothing, including boots, gloves, lab coat, apron or coveralls, as appropriate, to prevent skin contact.
Eye Protection: Use chemical safety goggles and/or full face shield where dusting or splashing of solutions is possible. Maintain eye wash fountain and quick-drench facilities in work area.
Other Control Measures: Maintain good housekeeping in work area. Handle in accordance with good industrial hygiene and safety practice. Wash hands after handling.
9. Physical and Chemical Properties
Appearance: Colorless to light, greenish-yellow liquid.
Odor: Pungent, Chlorine like.
Odor threshold: Not available.
pH: >9
Relative density: 1.1 to 1.2
Boiling Point: >100C
Melting Point: 13.6C
Flash point: No data found.
Auto-ignition temperature: No data found.
Decomposition temperature: No data found.
Upper/lower flammability or explosive limits: No data found.
Vapor pressure: No data found.
Vapor density: No data found.
Evaporation rate: No data found.
Flammability (solid, gas): No data found.
Partition coefficient: n-octanol/water: No data found.
Solubility: Slightly soluble in water
Viscosity: No data found.
10. Stability and Reactivity
Stability: It is stable under ordinary conditions of use and storage. Contact with most metals will generate flammable hydrogen gas. Contact with water will generate considerable heat. Reacts with amines and ammonia compounds to form explosively unstable compounds. May be corrosive to metals. May be corrosive to: Aluminum, stainless steel, carbon steel, copper, bronze.
Hazardous Decomposition Products: Hydrogen chloride gas, Chlorine and Sodium oxide..
Hazardous Polymerization: Will not occur.
Incompatibilities: Powdered metals, Amines, Ammonia, Strong acids, Organic materials, Methanol, Forms shock-sensitive mixtures with certain other materials. Avoid Strong reducing agents and Heat.
Conditions to Avoid: Heat, moisture, flames, ignition sources and incompatibles.
11. Toxicological Information
Oral rat LD50: NA.
Carcinogenic Effects: Not a reported carcinogen by NTP ACGIH OSHA. IARC: 3 - Group 3: Not classifiable as to its carcinogenicity to humans (Sodium hypochlorite).
Teratogenic Effects: No data found.
Mutagenic Effects: No data found.
Developmental Toxicity: No data found.
Reproductive Effects: No data found.
12. Ecological Information
Environmental Toxicity:
Toxicity to fish: LC50 Western mosquitofish (Gambusia affinis) 125 mg/l, 96 hours
Very toxic to aquatic life. Avoid release to the environment.
Persistence and Degradability: Unlikely to persist due to water solubility.
Mobility: Mobile due to water solubility.
This substance/mixture contains no components considered to be either persistent, bioaccumulative and toxic (PBT), or very persistent and very bioaccumulative (vPvB) at levels of 0.1% or higher.
13. Disposal Considerations
Whatever cannot be saved for recovery or recycling should be handled as hazardous waste and sent to a RCRA approved waste facility.
14. Transport Information
Land Transport DOT USA, TDG Canada & ADR/RID Europe:
Proper Shipping Name: SODIUM HYPOCHLORITE
Hazard Class: 8
UN/NA: UN1791
Packing Group: III
Air Transport IATA/ICAO:
Proper Shipping Name: Hypochlorite solution
Hazard Class: 8
UN/NA: UN1791
Packing Group: III
Sea Transport IMDG/IMO:
Proper Shipping Name: Hypochlorite solution
Hazard Class: 8
UN/NA: UN1791
Packing Group: III
15. Regulatory Information
SARA 311/312: See section 2.
California Prop 65 Components: This product does not contain any chemicals known to the State of California to cause cancer, birth, or any other reproductive defects.
Section 16. Other Information
European Labeling in Accordance with EC Directives:
H314 - Causes severe skin burns and eye damage.
H400 - Very toxic to aquatic life.
DISCLAIMER: The information and recommendations set forth herein are presented in good faith and believed correct as of the date hereof. It is compiled from various sources, and it is not necessarily all inclusive nor fully adequate in every circumstance. In addition, these suggestions should not be confused with nor followed in violation of applicable laws, regulations, rules, or insurance requirements applicable. This SDS MSDS sheet is intended only as a guide to the appropriate precautionary handling of the material by a professionally trained person using this product. Individuals receiving the information must exercise their independent judgment in determining its appropriateness for a particular purpose. This shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship. In no case shall our company be liable to loss or damages by the product user.
Please visit Main Page of Hypo or Soda Bleach or Sodium Hypochlorite Solution Pentahydrate Suppliers.
American Molecules, also known as ammol.org is a distributor, supplier and manufacturers' representative of all types of Pharmaceuticals, Functional Ingredients, Excipients and Specialty Chemicals in Texas USA. Our principals manufacture supply and export USP NF BP, Ph Eur, etc grades of chemicals pure and reagent grade, mineral fortifiers, FCC food grade. Tailor made particle size and customized specifications are offered. The principal's facility is having one or more of the certifications like FDA approval and GLP, cGMP, ISO9001, ISO14001, ISO/IEC 17025, ISO22000, FSSC 22000, ISO45001, FSSAI, Kosher, HALAL, COPP, WHO-GMP certified and Written Confirmation (WC) for export to Europe is available. The manufacturers suppliers and exporters observe WHO Good Manufacturing Practices and Good Laboratory Practices.
Suppliers and Manufacturers' Representative:
9910 Bent Oak Dr
Houston, TX 77040, USA
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665
Email: info@ammol.org