 |
Sodium Dodecyl Sulfate or Sodium Lauryl Sulfate SDS Safety Data Sheet of Supplier Exporter Manufacturers' Representative |
Email: info@ammol.org |
Call Toll Free +1-855-552-6665 |
Sodium Dodecyl Sulfate or Sodium Lauryl Sulfate
CAS Number: 151-21-3
Molecular Formula: NaC12H25SO4
Molecular Weight: 288.37
Sodium Dodecyl Sulfate or Sodium Lauryl Sulfate
Sodium lauryl sulfate or Sodium dodecyl sulfate SDS, Safety Data Sheet
MSDS, Material Safety Data Sheet 04-Feb-24
SECTION 1. PRODUCT IDENTIFICATION
Product Name & Other Names: Sodium lauryl sulfate or Sodium dodecyl sulfate or Sodium lauryl sulphate or Sodium dodecyl sulphate
Synonyms: Lauryl sulfate sodium salt, Sodium lauryl sulphate, Dodecyl sodium sulphate, Dodecyl sulfate sodium salt.
CAS Number: 151-21-3
EINECS EC Number: 205-788-1
Relevant uses and uses advised against (if any): Industrial Manufacturing.
Supplier: American Molecules, 9910 Bent Oak Dr, Houston, TX 77040, USA.
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665.
In case of emergency contact: Will be given with the supply.
SECTION 2. HAZARDS IDENTIFICATION
GHS, Globally Harmonized System Classification in accordance with 29 CFR 1910
Classification according to Regulation (EC) No 1272/2008
Flammable solids (Category 1)
Acute toxicity, oral (Category 4)
Acute toxicity, inhalation (Category 4)
Skin corrosion/irritation (Category 2)
Serious eye damage (Category 1)
Specific target organ toxicity, single exposure; Respiratory tract irritation (Category 3)
Hazardous to the aquatic environment, acute hazard (Category 2)
Labeling according to GHS USA & Regulation (EC) No 1272/2008
GHS Label Elements  Flammable Solids |
GHS Label Elements |
Signal Words: Danger
Hazard statements:
H228: Flammable solid.
H302 + H332: Harmful if swallowed
H315: Causes skin irritation.
H318: Causes serious eye damage.
H335: May cause respiratory irritation.
H401: Toxic to aquatic life.
Precautionary statements:
P210: Keep away from heat/sparks/open flames/hot surfaces – No smoking.
P240: Ground/bond container and receiving equipment.
P241: Use explosion-proof electrical/ventilating/light/…/equipment.
P261: Avoid breathing dust/ fume/ gas/ mist/ vapors/ spray.
P262: Do not get in eyes, on skin, or on clothing.
P270: Do not eat, drink or smoke when using this product.
P271: Use only outdoors or in a well-ventilated area.
P280: Wear protective gloves/protective clothing/eye protection/face protection.
P301+P312: IF SWALLOWED: Call a POISON CENTER or doctor/physician if you feel unwell.
P302+P352: IF ON SKIN: Wash with soap and water.
P304+340: IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing.
P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P337+P313: If eye irritation persists: Get medical advice/ attention.
P370+378: In case of fire: Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide for extinction.
SECTION 3. COMPOSITION / INFORMATION ON INGREDIENTS
Product Name & Other Names: Sodium lauryl sulfate or Sodium dodecyl sulfate or Sodium lauryl sulphate or Sodium dodecyl sulphate
Synonyms: Lauryl sulfate sodium salt, Sodium lauryl sulphate, Dodecyl sodium sulphate, Dodecyl sulfate sodium salt.
CAS Number: 151-21-3
EINECS EC Number: 205-788-1
SECTION 4. FIRST AID MEASURES
Always seek medical attention after first aid measures are provided.
Eye Contact: Do not allow victim to rub eye (s). Let the eye (s) water naturally for a few minutes. If particle/dust does not dislodge, flush with lukewarm, gently flowing water for 5 minutes or until particle/dust is removed, while holding eyelid (s) open. If irritation persists, obtain medical attention. DO NOT attempt to manually remove anything stuck to the eye.
Skin Contact: Remove contaminated clothing, shoes and leather goods (e.g. watchbands, belts). Quickly and gently blot or brush away excess chemical. Wash gently and thoroughly with lukewarm gently flowing water and non-abrasive soap for 5 minutes. If irritation persists, repeat flushing. Obtain medical advice. Completely decontaminate clothing, shoes and leather goods before reuse or else discard.
Inhalation: If symptoms are experienced, remove source of contamination or move victim to fresh air. Obtain medical advice.
Ingestion: Never give anything by mouth if victim is rapidly losing consciousness or is unconscious or convulsing. Have victim rinse mouth thoroughly with water. DO NOT INDUCE VOMITING. Have victim drink 2 – 8 oz. (60 – 240 ml) of water.
SECTION 5. FIRE FIGHTING MEASURES
Fire and Explosion Hazards: Flammable Solids.
Extinguishing Media: Use means of extinction appropriate for the surrounding fire conditions such as water spray, carbon dioxide, dry chemical, or foam.
Fire Fighting: Apart from oxides of carbon. toxic fumes of sulfur dioxide may result from combustion. As with any fire, fire fighters should be fully trained and wear full protective clothing including an approved, self-contained breathing apparatus which supplies a positive air pressure within a full-face piece mask. Do not use water directly on material. Do not allow water run-off to enter sewers or watercourses. Use water spray to cool unopened containers.
SECTION 6. ACCIDENTAL RELEASE MEASURES
Procedures for Cleanup: Stop release if possible, to do so safely. Contain spill, isolate hazard area, and deny entry. Sweep up or vacuum. Place contaminated material in suitable, labeled containers for final disposal. Dispose of waste material consistent with the requirements of waste disposal authorities.
Personal Precautions: Gloves and coveralls or other protective clothing are recommended for persons responding to an accidental release. Close-fitting safety goggles may be necessary in some circumstances to prevent eye contact.
Environmental Precautions: This product can pose a threat to the environment. Contamination of soil and water should be prevented. Keep spillage from entering soil, streams, or sewers.
SECTION 7. HANDLING AND STORAGE
Precautions for safe handling: Apply according to good manufacturing and industrial hygiene practices. Ensure proper ventilation. Wash thoroughly after handling. Do not drink, eat or smoke while handling. Avoid contact with skin, eyes and clothing. Minimize dust generation. Avoid breathing dust/fumes/gas/mist/vapors/spray. Keep container tightly closed. Avoid ingestion and inhalation. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc).
Conditions for safe storage, including any incompatibilities: Keep away from sources of ignition - No smoking. Take measures to prevent the build-up of electrostatic charge. Store in cool, dry and ventilated area away from heat sources and protected from sunlight in tightly closed original container. Keep air contact to a minimum. generating dust and the release of dust into the workplace. Do not leave the material container open. Store protected from heat, sparks and ignition sources and incompatible materials. Avoid contact with skin and eyes. Do not store with incompatible materials like oxidizing agents
SECTION 8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Ventilation System: A system of local and/or general exhaust is recommended to keep employee exposures as low as possible.
Personal Respirators (NIOSH Approved): For conditions of use where exposure to dust or mist is apparent and engineering controls are not feasible, a particulate respirator may be worn.
Skin Protection: Wear protective gloves and clean body-covering clothing.
Eye Protection: Use chemical safety goggles and/or full face shield where dusting or splashing of solutions is possible. Maintain eye wash fountain and quick-drench facilities in work area.
Other Control Measures: Maintain good housekeeping in work area. Handle in accordance with good industrial hygiene and safety practice. Wash hands after handling.
SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance: It is colorless, solid.
Odor: Odorless.
Odor threshold: Not applicable.
pH: 9 to 10 @ 10% solution.
Relative density: 0.37.
Melting point/freezing point: 204C - 207C.
Initial boiling point and boiling range: No data found.
Flash point: No data found.
Auto-ignition temperature: No data found.
Decomposition temperature: No data found.
Upper/lower flammability or explosive limits: No data found.
Vapor pressure: Negligible @ 20C.
Vapor density: No data found.
Evaporation rate: No data found.
Flammability (solid, gas): No data found.
Partition coefficient: n-octanol/water: No data found.
Solubility(ies): Soluble in water.
Viscosity: No data found.
SECTION 10. STABILITY AND REACTIVITY
Stability and Reactivity: Stable and not considered reactive under normal temperatures and pressures. Hazardous polymerization or runaway reactions will not occur.
Incompatibilities: Oxidizing agents. Avoid excessive heat.
Hazardous Decomposition Products: High temperature operations will generate carbon oxide fume. Under such conditions, sulfur dioxide will also be generated and can cause respiratory distress.
SECTION 11. TOXICOLOGICAL INFORMATION
Acute Toxicity (Oral LD50): > 1,200 mg/kg Rat
LC50 Inhalation - Rat - 1 h - > 3,900 mg/m3
Carcinogenicity: No component of this product present at levels greater than or equal to 0.1% is identified as possible or confirmed human carcinogen by IARC, ACGIH, OSHA and NTP.
Teratogenic Effects: No data found.
Mutagenic Effects: No data found.
Developmental Toxicity: No data found.
Reproductive Effects: No data found.
The sodium salt of dodecyl sulfate has been reported to cause pulmonary sensitization resulting in hyperactive airway dysfunction and pulmonary allergy accompanied by fatigue, malaise, and aching.
SECTION 12. ECOLOGICAL INFORMATION
Toxicity to fish: flow-through test LC50 - Pimephales promelas (fathead minnow) - 29 mg/l-96 h
Toxicity to daphnia and other aquatic invertebrates: flow-through test EC50 - Daphnia dubia (water flea) - 5.55 mg/l - 48 h
Persistence and Degradability: Readily degradable.
Mobility: Likely to be mobile due to water solubility.
Bioaccumulation/ Accumulation: No data found.
Results of PBT and vPvB assessment: No data found.
SECTION 13. DISPOSAL CONSIDERATIONS
Do not wash the material down drain. Put uncontaminated material back into the process if possible. Place contaminated material in suitable, labeled containers for disposal. Dispose of waste material consistent with the requirements of waste disposal authorities.
SECTION 14. TRANSPORT INFORMATION
Land Transport DOT USA, TDG Canada & ADR/RID Europe:
UN Number: 1325
UN proper shipping name: Flammable solids, organic, n.o.s. (Sodium dodecyl sulphate)
Transport hazard class(es): 4.1; Packaging group: III
Air Transport IATA/ICAO:
UN Number: 1325
UN proper shipping name: Flammable solids, organic, n.o.s. (Sodium dodecyl sulphate)
Transport hazard class(es): 4.1; Packaging group: III
Sea Transport IMDG/IMO:
UN Number: 1325
UN proper shipping name: Flammable solids, organic, n.o.s. (Sodium dodecyl sulphate)
Transport hazard class(es): 4.1; Packaging group: III
SECTION 15. REGULATORY INFORMATION
USA:
SARA 311/312: See section 2.
California Prop 65 Components: This product does not contain any chemicals known to the State of California to cause cancer, birth, or any other reproductive defects.
SECTION 16 - ADDITIONAL INFORMATION
European Labeling in Accordance with EC Directives:
H228: Flammable solid.
H302 + H332: Harmful if swallowed
H315: Causes skin irritation.
H318: Causes serious eye damage.
H335: May cause respiratory irritation.
H401: Toxic to aquatic life.
DISCLAIMER: The information and recommendations set forth herein are presented in good faith and believed correct as of the date hereof. It is compiled from various sources, and it is not necessarily all inclusive nor fully adequate in every circumstance. In addition, these suggestions should not be confused with nor followed in violation of applicable laws, regulations, rules, or insurance requirements applicable. This SDS MSDS sheet is intended only as a guide to the appropriate precautionary handling of the material by a professionally trained person using this product. Individuals receiving the information must exercise their independent judgment in determining its appropriateness for a particular purpose. This shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship. In no case shall our company be liable to loss or damages by the product user.
Please visit Main Page of or Sodium Lauryl Sulfate or Sodium Dodecyl Sulfate Suppliers.
American Molecules, also known as ammol.org is a distributor, supplier and manufacturers' representative of all types of Pharmaceuticals, Functional Ingredients, Excipients and Specialty Chemicals in Texas USA. Our principals manufacture supply and export USP NF BP, Ph Eur, etc grades of chemicals pure and reagent grade, mineral fortifiers, FCC food grade. Tailor made particle size and customized specifications are offered. The principal's facility is having one or more of the certifications like FDA approval and GLP, cGMP, ISO9001, ISO14001, ISO/IEC 17025, ISO22000, FSSC 22000, ISO45001, FSSAI, Kosher, HALAL, COPP, WHO-GMP certified and Written Confirmation (WC) for export to Europe is available. The manufacturers suppliers and exporters observe WHO Good Manufacturing Practices and Good Laboratory Practices.
Suppliers and Manufacturers' Representative:
9910 Bent Oak Dr
Houston, TX 77040, USA
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665
Email: info@ammol.org