 |
Zinc Oxide SDS Safety Data Sheet of Supplier Exporter Manufacturers' Representative |
Email: info@ammol.org |
Call Toll Free +1-855-552-6665 |
Zinc Oxide
CAS Number: 1314-13-2
Molecular Formula: ZnO
Molecular Weight: 81.39
Zinc Oxide
Zinc Oxide SDS, Safety Data Sheet
MSDS Sheet, Material Safety Data Sheet 04-Feb-24
Section 1: Chemical Product and Company Identification
Product Name & Other Names: Zinc Oxide
CAS Number: 1314-13-2
EINECS EC Number: 215-222-5
Relevant uses and uses advised against (if any): Industrial Manufacturing.
Supplier: American Molecules, 9910 Bent Oak Dr, Houston, TX 77040, USA.
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665.
In case of emergency contact: Will be given with the supply.
Section 2: Hazards Identification
GHS, Globally Harmonized System Classification in accordance with 29 CFR 1910
Classification according to Regulation (EC) No 1272/2008
Hazardous to the aquatic environment, long-term hazard Category 1 (H410)
Labeling according to GHS & Regulation (EC) No 1272/2008
GHS Label Elements  Aquatic Toxicity |
Signal Words: Warning
Hazard statements:
H410: Very toxic to aquatic life with long lasting effects
Precautionary statements:
P273: Avoid release to the environment.
P391: Collect spillage.
Section 3: Composition and Information on Ingredients
Product Name & Other Names: Zinc Oxide
CAS Number: 1314-13-2
EINECS EC Number: 215-222-5
Section 4: First Aid Measures
Always get medical attention after the first aid is over.
Eye Contact: Flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical aid.
Skin Contact: After contact with skin, wash immediately with plenty of water. Gently and thoroughly wash the contaminated skin with running water and non-abrasive soap. Be particularly careful to clean folds, crevices, creases and groin. Cover the irritated skin with an emollient. If irritation persists, seek medical attention.
Inhalation: Remove from exposure and move to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical aid if cough or other symptoms appear.
If swallowed: Never give anything by mouth to an unconscious person. Rinse mouth with water. Consult a physician.
Section 5: Fire and Explosion Data
Flammability of the Product: Non-flammable.
Products of Combustion: Zinc & .Zinc Oxide.
Suitable extinguishing media: Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.
Explosion Hazards in Presence of Various Substances:
Risks of explosion of the product in presence of mechanical impact: Not available.
Risks of explosion of the product in presence of static discharge: Not available.
Fire Fighting Media and Instructions: Not applicable. However, wear self contained breathing apparatus for firefighting if necessary.
Section 6: Accidental Release Measures
Personal precautions, protective equipment and emergency procedures: Avoid breathing dust/fumes/gas/mist/vapors/spray. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc.). Restrict unprotected personnel from the area. Prevent any contact with hot surfaces. Do not approach facing the wind.
Environmental precautions: Do not let the product enter drains, soil or water sources.
Methods and materials used for containment Cleanup procedures and Storage: Contain spilled material. Use a shovel to put the material into a convenient waste disposal container. Prevent further leakage or spillage if safe to do so. Do not let product enter drains. Discharge into the environment must be avoided.
Section 7: Handling and Storage
Precautions for safe handling: Avoid ingestion and inhalation. Apply according to good manufacturing and industrial hygiene practices. Ensure proper ventilation. Wash thoroughly after handling. Do not drink, eat or smoke while handling. Avoid contact with skin, eyes and clothing. Minimize dust generation. Avoid breathing dust/fumes/gas/mist/vapors/spray. Keep container tightly closed. Avoid ingestion and inhalation. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc.).
Conditions for safe storage, including any incompatibilities: Store in cool, dry and ventilated area away from heat sources and protected from sunlight in tightly closed original container. Keep air contact to a minimum. Do not leave the material container open. Store protected from heat, sparks and ignition sources and incompatible materials. Avoid contact with skin and eyes. Avoid inhalation of dust/mist/vapor. Do not store with incompatible materials like strong oxidizing agents & acids.
Section 8: Exposure Controls/Personal Protection
Occupational Exposure Limits:
USA ACGIH, ACGIH TWA (mg/m³): 2 mg/m³
USA ACGIH, ACGIH STEL (mg/m³): 10 mg/m³
USA OSHA, OSHA PEL (TWA) (mg/m³): 5 mg/m³
USA NIOSH, NIOSH REL (TWA) (mg/m³): 5 mg/m³
Engineering Controls: Use process enclosures, local exhaust ventilation, or other engineering controls to keep airborne levels below recommended exposure limits.
Personal Protection: Safety glasses. Lab coat. Dust respirator. Be sure to use an approved/certified respirator or equivalent. Gloves.
Personal Protection in Case of a Large Spill: Splash goggles. Full suit. Dust respirator. Boots. Gloves. A self-contained breathing apparatus should be used to avoid inhalation of the product. Suggested protective clothing might not be enough; consult a specialist BEFORE handling this product.
Section 9: Physical and Chemical Properties
Physical state and appearance: Zinc oxide is white solid. (Powdered solid.)
Odor: Odorless.
Odor threshold: Not applicable.
pH (1% soln/water): around 7.
Relative density: 5.61
Melting Point: 1975C.
Initial boiling point and boiling range: No data found.
Flash point: No data found.
Auto-ignition temperature: No data found.
Decomposition temperature: No data found.
Upper/lower flammability or explosive limits: No data found.
Vapor pressure: No data found.
Vapor density: No data found.
Evaporation rate: No data found.
Flammability (solid, gas): No data found.
Partition coefficient: n-octanol/water: No data found.
Solubility: Very slightly soluble in cold water, hot water.
Viscosity: No data found.
Section 10: Stability and Reactivity Data
Stability: Zinc oxide is stable.
Incompatibility with various substances: Strong oxidizing agents & acids.
Polymerization: No.
Section 11: Toxicological Information
LD50 Oral - mouse - 7.950 mg/kg
LC50 Inhalation - mouse - 2.500 mg/m3
Carcinogenicity: Not listed as a suspected/confirmed carcinogen by ACGIH, IARC, NTP, OSHA.
Mutagenic Effects: No data found.
Developmental Toxicity: No data found.
Reproductive Effects: No data found.
Other Toxic Effects on Humans: Slightly hazardous in case of skin contact (irritant), of ingestion, of inhalation.
Section 12: Ecological Information
Toxicity to fish: LC50 - Oncorhynchus mykiss (rainbow trout) - 1,1 mg/l - 96,0 h
Toxicity to daphnia and other aquatic invertebrates: EC50 - Daphnia magna (Water flea) - 0,098 mg/l - 48 h
Products of Biodegradation: Possibly hazardous short-term degradation products are not likely. However, long term degradation products may arise.
Toxicity of the Products of Biodegradation: Insoluble in water. (can be separated from aqueous systems by sedimentation and/or filtration techniques. Predicted to have low mobility in soil.
Section 13: Disposal Considerations
Waste Disposal: Dispose all waste in accordance with legal requirement.
Section 14: Transport Information
Land Transport DOT USA: Not a DOT controlled material (United States).
Land Transport ADR/RID Europe:
UN3077: ENVIRONMENTALLY HAZARDOUS SUBSTANCE SOLID N.O.S. (Zinc Oxide)
Transport hazard Classes: 9
Packing group: III
Environmental hazards: Yes
Sea Transport IMDG/IMO:
UN3077: ENVIRONMENTALLY HAZARDOUS SUBSTANCE SOLID N.O.S. (Zinc Oxide)
Transport hazard Classes: 9
Packing group: III
Environmental hazards: Yes
Air Transport IATA/ICAO:
UN3077: ENVIRONMENTALLY HAZARDOUS SUBSTANCE SOLID N.O.S. (Zinc Oxide)
Transport hazard Classes: 9
Packing group: III
Environmental hazards: Yes
Section 15: Other Regulatory Information
USA:
SARA 311/312 Hazards: See section 2.
California Prop. 65 Components: This product does not contain any chemicals known to State of California to cause cancer, birth defects, or any other reproductive harm.
Section 16 - Additional Information
European Labeling in Accordance with EC Directives:
H410 = Very toxic to aquatic life with long lasting effects.
DISCLAIMER: The information and recommendations set forth herein are presented in good faith and believed correct as of the date hereof. It is compiled from various sources, and it is not necessarily all inclusive nor fully adequate in every circumstance. In addition, these suggestions should not be confused with nor followed in violation of applicable laws, regulations, rules, or insurance requirements applicable. This SDS MSDS sheet is intended only as a guide to the appropriate precautionary handling of the material by a professionally trained person using this product. Individuals receiving the information must exercise their independent judgment in determining its appropriateness for a particular purpose. This shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship. In no case shall our company be liable to loss or damages by the product user.
Please visit Main Page of Zinc Oxide Suppliers.
American Molecules, also known as ammol.org is a distributor, supplier and manufacturers' representative of all types of Pharmaceuticals, Functional Ingredients, Excipients and Specialty Chemicals in Texas USA. Our principals manufacture supply and export USP NF BP, Ph Eur, etc grades of chemicals pure and reagent grade, mineral fortifiers, FCC food grade. Tailor made particle size and customized specifications are offered. The principal's facility is having one or more of the certifications like FDA approval and GLP, cGMP, ISO9001, ISO14001, ISO/IEC 17025, ISO22000, FSSC 22000, ISO45001, FSSAI, Kosher, HALAL, COPP, WHO-GMP certified and Written Confirmation (WC) for export to Europe is available. The manufacturers suppliers and exporters observe WHO Good Manufacturing Practices and Good Laboratory Practices.
Suppliers and Manufacturers' Representative:
9910 Bent Oak Dr
Houston, TX 77040, USA
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665
Email: info@ammol.org