American Molecules - Ammol.org USA

D-Gluconic Acid Monopotassium Salt or Potassium Gluconate Anhydrous Monohydrate SDS Safety Data Sheet of Supplier Exporter Manufacturers' Representative

Call Toll Free +1-855-552-6665
Toll Free: 1-855-55-AMMOL

D-Gluconic Acid Monopotassium Salt or Potassium Gluconate
CAS Number: 299-27-4 Anhydrous, 35398-15-3 Monohydrate

Molecular Formula: C6H11KO7 Anhydrous
Molecular Weight: 234.25 Anhydrous

Potassium Gluconate Suppliers
D-Gluconic Acid Monopotassium Salt or Potassium Gluconate

Potassium Gluconate SDS, Safety Data Sheet
MSDS Sheet, Material Safety Data Sheet
 04-Feb-24

Section 1: Chemical Product Identification

Product Name & Other Names: Potassium Gluconate or D-Gluconic acid monopotassium salt or Monopotassium Gluconate or Potassium D-gluconate
CAS#: 299-27-4
EINECS EC Number: 206-074-2
Relevant uses and uses advised against (if any): Industrial Manufacturing.
Supplier: American Molecules, 9910 Bent Oak Dr, Houston, TX 77040, USA.
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665.
In case of emergency contact: Will be given with the supply.

Section 2: Hazards Identification

GHS, Globally Harmonized System Classification in accordance with 29 CFR 1910
Classification according to Regulation (EC) No 1272/2008

Not a hazardous substance or mixture according to Regulation (EC) No. 1272/2008.
This substance is not classified as dangerous according to Directive 67/548/EEC.

Labeling according to GHS & Regulation (EC) No 1272/2008

GHS Label Elements
NONE

Signal Word: None

Precautionary statements:
P261: Avoid breathing dust/fume/gas/mist/vapors/spray.
P262: Do not get in eyes, on skin, or on clothing.
P281: Use personal protective equipment as required.
P302+P352 - IF ON SKIN: Wash with plenty of soap and water.
P304 + P340 - IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing.
P305 + P351 + P338 - IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.

Section 3: Composition and Information on Ingredients

Product Name & Other Names: Potassium Gluconate or D-Gluconic acid monopotassium salt or Monopotassium Gluconate or Potassium D-gluconate
CAS#: 299-27-4
EINECS EC Number: 206-074-2

Section 4: First Aid Measures

Always get medical attention after the first aid is over.

Eye Contact: Check for and remove any contact lenses. In case of contact, immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention if irritation occurs.
Skin Contact: Wash with soap and water. Cover the irritated skin with an emollient. Get medical attention if irritation develops.
Inhalation: If Potassium Gluconate is inhaled, remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention.
Ingestion: Do Not induce vomiting unless directed to do so by medical personnel. If large quantities of this material are swallowed, call a physician immediately. Loosen tight clothing.
Notes to Physician: Provide general supportive measures and treat symptomatically.

Section 5: Fire and Explosion Data

Flammability of the Product: Not classed as fire hazard but it may be combustible at high temperature.
Products of Combustion: Oxides of Potassium and carbon along with fumes .
Fire Fighting Media and Instructions: Use DRY chemical powder, water spray, carbon dioxide, fog or foam. Do not use water jet. Cool containers exposed to flames with water until well after the fire is out.

Section 6: Accidental Release Measures

Personal precautions, protective equipment, and emergency procedures: Avoid breathing dust/fumes/gas/mist/vapors/spray. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc.). Restrict unprotected personnel from the area. Prevent any contact with hot surfaces. Do not approach facing the wind.
Environmental precautions: Do not let the product enter drains, soil, or water sources.
Methods and materials used for containment Cleanup procedures and Storage: Contain spilled material. Do not let the product enter drains. Use a shovel to put the material into a convenient waste disposal container. Finish cleaning by spreading water on the contaminated surface and allow evacuating as per law.

Section 7: Handling and Storage

Precautions for safe handling: Apply according to good manufacturing and industrial hygiene practices. Ensure proper ventilation. In case of insufficient ventilation, wear suitable respiratory equipment. Wash thoroughly after handling. Do not drink, eat, or smoke while handling. Avoid contact with skin, eyes, and clothing. Minimize dust generation. Avoid breathing dust/fumes/gas/mist/vapors/spray. Keep container tightly closed. Avoid ingestion and inhalation. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc.).
Conditions for safe storage, including any incompatibilities: Store in cool, dry, and ventilated area away from heat sources and protected from sunlight in tightly closed original container. Keep air contact to a minimum. Store protected from heat, sparks and ignition sources and incompatible materials. Avoid contact with skin and eyes. Avoid inhalation of dust/mist/vapor. Do not store with incompatible materials like strong oxidizing agents.

Section 8: Exposure Controls/Personal Protection

Engineering Controls: No exposure standards allocated. Use process enclosures, local exhaust ventilation, or other engineering controls to keep airborne levels low.
Ventilation System: A system of local and/or general exhaust is recommended to keep employee exposures as low as possible.
Personal Respirators (NIOSH Approved): For conditions of use where exposure to dust or mist is apparent and engineering controls are not feasible, a particulate respirator may be worn.
Skin Protection: Wear protective gloves and clean body-covering clothing.
Eye Protection: Use chemical safety goggles and/or full face shield where dusting or splashing of solutions is possible. Maintain eye wash fountain and quick-drench facilities in work area.
Other Control Measures: Maintain good housekeeping in work area. Handle in accordance with good industrial hygiene and safety practice. Wash hands after handling.

Section 9: Physical and Chemical Properties

Physical state and appearance: Solid. (Off-White Powder)
Odor: Odorless.
Odor threshold: Not applicable.
pH (1% soln/water): 7-10.
Relative density: No data found.
Boiling Point: Decomposes.
Melting Point: Decomposes.
Critical Temperature: No data found.
Flash point: No data found.
Auto-ignition temperature: No data found.
Decomposition temperature: No data found.
Upper/lower flammability or explosive limits: No data found.
Vapor Pressure: No data found.
Vapor Density: No data found.
Evaporation rate: No data found.
Flammability (solid, gas): No data found.
Partition coefficient: n-octanol/water: No data found.
Solubility: Soluble in cold water, hot water. Freely soluble in glycerin; practically insoluble in dehydrated alcohol, in ether, in benzene, and in chloroform.
Viscosity: No data found.

Section 10: Stability and Reactivity Data

Stability: Stable.
Incompatibility with various substances: Oxidizing agents
Hazardous Decomposition Products: May form carbon dioxide and carbon monoxide, various hydrocarbons fumes and oxide of Potassium.
Polymerization: Will not occur.

Section 11: Toxicological Information

Toxicity to Animals:
LD50 Oral: 9100 mg/kg Mouse
LD50 Oral: 6060 mg/kg Rat
Carcinogenicity: No component of this product present at levels greater than or equal to 0.1% is identified as possible or confirmed human carcinogen by IARC, ACGIH, OSHA and NTP.
Teratogenic Effects: No data found.
Mutagenic Effects: No data found.
Developmental Toxicity: No data found.
Reproductive Effects: No data found.

Section 12: Ecological Information

Toxicity to fish: No data found.
Persistence and Degradability: Unlikely to persist due to water solubility.
Mobility: Likely to be mobile due to water solubility.
Bioaccumulation/ Accumulation: No data found.
Results of PBT and vPvB assessment: No data found.

Section 13: Disposal Considerations

Waste Disposal: To be disposed as per legal requirement.

Section 14: Transport Information

Land Transport DOT USA, TDG Canada & ADR/RID Europe: Not regulated.
Air Transport IATA/ICAO: Not regulated.
Sea Transport IMDG/IMO: Not regulated.

Section 15: Other Regulatory Information

USA:
SARA 311/312 Hazards: See section 2.
California Prop. 65 Components: This product does not contain any chemicals known to State of California to cause cancer, birth defects, or any other reproductive harm.

Section 16: Other Information

DISCLAIMER: The information and recommendations set forth herein are presented in good faith and believed correct as of the date hereof. It is compiled from various sources, and it is not necessarily all inclusive nor fully adequate in every circumstance. In addition, these suggestions should not be confused with nor followed in violation of applicable laws, regulations, rules, or insurance requirements applicable. This SDS MSDS sheet is intended only as a guide to the appropriate precautionary handling of the material by a professionally trained person using this product. Individuals receiving the information must exercise their independent judgment in determining its appropriateness for a particular purpose. This shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship. In no case shall our company be liable to loss or damages by the product user.

Please visit Main Page of D-Gluconic Acid Monopotassium Salt or Potassium Gluconate Suppliers.

American Molecules, also known as ammol.org is a distributor, supplier and manufacturers' representative of all types of Pharmaceuticals, Functional Ingredients, Excipients and Specialty Chemicals in Texas USA. Our principals manufacture supply and export USP NF BP, Ph Eur, etc grades of chemicals pure and reagent grade, mineral fortifiers, FCC food grade. Tailor made particle size and customized specifications are offered. The principal's facility is having one or more of the certifications like FDA approval and GLP, cGMP, ISO9001, ISO14001, ISO/IEC 17025, ISO22000, FSSC 22000, ISO45001, FSSAI, Kosher, HALAL, COPP, WHO-GMP certified and Written Confirmation (WC) for export to Europe is available. The manufacturers suppliers and exporters observe WHO Good Manufacturing Practices and Good Laboratory Practices.

Pallet Drums Bottles Pail Container

Suppliers and Manufacturers' Representative:
American Molecules - Ammol.org USA
9910 Bent Oak Dr
Houston, TX 77040, USA
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665
Email: info@ammol.org