 |
D-Gluconic Acid Monopotassium Salt or Potassium Gluconate Anhydrous Monohydrate USP FCC Food Grade Supplier Exporter Manufacturers' Representative |
Email: info@ammol.org |
Call Toll Free +1-855-552-6665 |
D-Gluconic Acid Monopotassium Salt or Potassium Gluconate
CAS Number: 299-27-4 Anhydrous, 35398-15-3 Monohydrate
Molecular Formula: C6H11KO7 Anhydrous
Molecular Weight: 234.25 Anhydrous
D-Gluconic Acid Monopotassium Salt or Potassium Gluconate
Potassium Gluconate USP Grade Specifications
C6H11KO7(anhydrous) -- 234.25
d-Gluconic acid, monopotassium salt.
Monopotassium d-gluconate -- CAS 299-27-4
Monohydrate 252.26 -- CAS 35398-15-3
Potassium Gluconate is anhydrous or contains one molecule of water of hydration. It contains not less than 97.0 percent and not more than 103.0 percent of C6H11KO7, calculated on the dried basis.
Label it to indicate whether it is anhydrous or the monohydrate.
Identification:
A: Infrared Absorption.
B: It responds to the flame test for Potassium.
C: It responds to Identification test B for Gluconate under Calcium Gluconate.
Loss on drying: Dry it in vacuum at 105C for 4 hours: the anhydrous form loses not more than 3.0% of its weight, and the monohydrate loses between 6.0% and 7.5% of its weight.
Heavy metals: Dissolve 1 g in 10 mL of water, add 6 mL of 3 N hydrochloric acid, and dilute with water to 25 mL: the limit is 0.002%.
Reducing substances: Transfer 1.0 g to a 250-mL conical flask, dissolve in 10 mL of water, and add 25 mL of alkaline cupric citrate TS. Cover the flask, boil gently for 5 minutes, accurately timed, and cool rapidly to room temperature. Add 25 mL of 0.6 N acetic acid, 10.0 mL of 0.1 N iodine VS, and 10 mL of 3 N hydrochloric acid, and titrate with 0.1 N sodium thiosulfate VS, adding 3 mL of starch TS as the endpoint is approached. Perform a blank determination, omitting the specimen, and note the difference in volumes required. Each mL of the difference in volume of 0.1 N sodium thiosulfate consumed is equivalent to 2.7 mg of reducing substances (as dextrose): the limit is 1.0%.
Potassium Gluconate FCC Food Grade Specifications
D-Gluconic Acid, Monopotassium Salt; Monopotassium DGluconate
C6H11KO7 -- Formula weight, anhydrous 234.25
C6H11KO7-H2O -- Formula weight, monohydrate 252.26
CAS: anhydrous 299-27-4
CAS: monohydrate 35398-15-3
DESCRIPTION
Potassium Gluconate occurs as a white or yellow-white, crystalline powder or granules. It is anhydrous or the monohydrate. It is freely soluble in water and in glycerin, slightly soluble in alcohol, and insoluble in ether.
REQUIREMENTS
Indicate whether it is anhydrous or the monohydrate.
Identification:
A. A sample responds to the flame test for Potassium.
B. Dissolve a quantity of sample in water, heating in a water bath at 60C if necessary, to obtain a Test Solution containing 10 mg/mL. Similarly, prepare a Standard Solution of USP Potassium Gluconate Reference Standard in water, diluting to 10 mg/mL. To prepare a Spray Reagent, dissolve 2.5 g of ammonium molybdate in about 50 mL of 2 N sulfuric acid in a 100-mL volumetric flask, add 1.0 g of ceric sulfate, swirl to dissolve, dilute with 2 N sulfuric acid to volume, and mix. Apply separate 5-L portions of the Test Solution and the Standard Solution on a suitable thin-layer chromatographic plate, coated with a 0.25-mm layer of chromatographic silica gel, and allow to dry. Develop the chromatogram in a solvent system consisting of a 50:30:10:10 mixture of alcohol, water, ammonium hydroxide, and ethyl acetate until the solvent front has moved about three-fourths of the length of the plate. Remove the plate from the chamber, and dry at 110C for 20 min. Allow to cool, and spray with Spray Reagent. After spraying, heat the plate at 110C for about 10 min. The principal spot obtained from the Test Solution corresponds in color, size, and Rf value to that obtained from the Standard Solution.
C. The infrared absorption spectrum of a mineral oil dispersion of the sample, previously dried, exhibits relative maxima at the same wavelengths as those of a similar preparation of USP Potassium Gluconate Reference Standard.
Assay: Not less than 98.0% of C6H11KO7, calculated on the dried basis.
Lead: Not more than 2 mg/kg.
Loss on Drying: Anhydrous: Not more than 3.0%; Monohydrate: Between 6.0% and 7.5%.
Reducing Substances: Not more than 1.0%.
Please visit SDS Safety Data Sheet of D-Gluconic Acid Monopotassium Salt or Potassium Gluconate Suppliers.
American Molecules, also known as ammol.org is a distributor, supplier and manufacturers' representative of all types of Pharmaceuticals, Functional Ingredients, Excipients and Specialty Chemicals in Texas USA. Our principals manufacture supply and export USP NF BP, Ph Eur, etc grades of chemicals pure and reagent grade, mineral fortifiers, FCC food grade. Tailor made particle size and customized specifications are offered. The principal's facility is having one or more of the certifications like FDA approval and GLP, cGMP, ISO9001, ISO14001, ISO/IEC 17025, ISO22000, FSSC 22000, ISO45001, FSSAI, Kosher, HALAL, COPP, WHO-GMP certified and Written Confirmation (WC) for export to Europe is available. The manufacturers suppliers and exporters observe WHO Good Manufacturing Practices and Good Laboratory Practices.
Suppliers and Manufacturers' Representative:
9910 Bent Oak Dr
Houston, TX 77040, USA
Call Toll Free: 1-855-55-AMMOL 1-855-552-6665
Email: info@ammol.org